0
lagerPowerpack micro, ESU LokSound

Artikelnr ESU 54671

Powerpack micro

395 kr

Du sparar 25 kr

Normalt cirkapris: 420 kr

I lager - Fler än 5 st

Frakt
Standard frakt  (29 kr inom Sverige)

Kör utan ström!

Anslut detta powerpack till din dekoder och du kan köra utan ström. Denna modul lagrar strömmen så om du har dålig kontakt eller avbrott någonstans så löser det sig ändå.
Passar Loksound V4, Lokpilot V4 och Loksound Micro V4 och Lokpilot micro V4.

Mått 22 x 10 x 8 mm.

The ESU Power Pack can be optionally connected to all LokPilot V4.0, LokPilot micro V4.0, LokSound V4.0 and LokSound micro V4.0 decoders and supplies your locomotive reliably with power to get over dirty tracks and longer switch crossings.

Sound, light and motor functions are buffered and thus enable your model to run up to 3 seconds without power, depending on the model´s power consumption.

The Power Pack has an integrated charging current which is controlled by the decoder. Therefore it can remain within the loco while it gets programmed. The load current is however, limited to avoid an excessive load on your booster, for this case there would be, several models in operation.

The buffer time can be restricted by writing a CV on the decoder side to make red signals lead to an exact signal stop.

The size of the Power Pack is approx. 22 x 10 x 8 mm which has to be considered during the installation.

A 3-pin cable connection between the decoder and the Power Pack is essential.


Andra har köpt